um, i dunno if this happens to a lot of people but its happended to me a couple of times and i can't figure it out...... but i make a level or in this case im just adding on to one, and i've done everything by the books and cant find any errors but it still crashes....

Is Jed crashing or your level?

If its Jed try reinstalling it. If its the level start with the usual suspects - make sure there are no errors in the consistency checker and that the settings in the consistency checker are right.

------------------
Have lightsaber will travel.

MikeC's Really Lame Home Page

I have a question pertaining to this topic. My level sometimes just shuts off. Like not to the main menu, but completely shuts JK off. I've checked the consistancy checker, and nothing. I thought it might be the templates, but it couldn't possibly be, because I used pre-existing templates, and change a few values. Like I make a turret without any AI. I simply take the AI line out of the template. Or I change the AI, or I make the person a little bit faster. . .etc. And it doesn't shut off in any pattern I can tell, except it more commonly does it when I fire a conc. Large explosions trigger it too. (When an Xtank explodes). What could cause such an error? Could it be the template? I doubt it.

my bad JK crashes

Try reinstalling Jed. If it happens when you use the 3d preview try messing with the 3d preview viewing options (RGB, ramp emulation etc).

ApoK - I don't have much experience with that prolem, but it might be a conflict between different things going on (different cogs for example).

------------------
Have lightsaber will travel.

MikeC's Really Lame Home Page

k thanks

mike.. i have a problem.. my level is 100% AOK in JED. consistency checker says it's good, etc., but whenever i try to save and test the level or try to access it through JK.. it says : "ERROR:Could not load level" Any idea why?


------------------
...I do believe that they think I am some sort of god.

-C-3P0 (ROTJ)

Look in the episode editor to make sure all the settings are right. Especially make sure it references the right .jkl file (that is often a problem if the .jed and .jkl file names are different).

Other things that could cause that... make sure you have a walkplayer. Also if you have more than 450 objects (3dos) in a level it will do that (found that out the hard way).

------------------
Have lightsaber will travel.

MikeC's Really Lame Home Page