it's when I make a stair case. if u look at it 1 way then it looks fine but if u look from the otherside it has a wall right there rather than the rest of the level. Is there a way to stop this or do I have to redisign it?

[This message has been edited by VSE_Android18 (edited January 27, 2001).]

Is it an adjoined surface? If it is it will be a simple matter of clicking on it in the 3D preview and setting the GEO to 0 in the item editor. If it unadjoined you will have to adjoin it to its opposite surface(s). This could take some cleaving or use of the "Join" command but either way I doubt your level will have to be scrapped.

------------------
La lova num botaffa

change the geo to 0 like the one said above ^